dSPACE DS1103 - Power Input Connector

Power Input Connector
Each power supply unit provides a power input connector. It is a 7-
pin, male connector with two high‑current pins. It is adapted from a
15‑pin Sub-D connector.
Objective
One mating connector with connecting leads is included in the
AutoBox package (up to TandemAutoBox Version 4.0 = two
connectors). The cable for AutoBox Version 4.0 is labeled CB402AB.
Matching cable
The following illustration shows the pinout (front view).
Connector pinout
Connector Pin Signal Pin Signal
1
2
A1
A2
3
4
5
A2 Positive supply voltage
1)
5 Reserved, do not use
2 Reserved, do not use 4 Remote control
2)
1 Reserved, do not use 3 Reserved, do not use
A1 Negative supply voltage (0 V)
1)
Up to AutoBox Version 3.0: 8 V … 60 V DC; AutoBox Version 4.0 and later: 6 V … 60 V DC; Up to Tandem-AutoBox Version
4.0: 10 V … 60 V DC.
2)
If you use the matching cable supplied by dSPACE the remote control line is connected to positive supply voltage within the
connector shell. This cable is intended for use with a laboratory power supply only.
s
Installing the Hardware
t
48
s
DS1103 Hardware Installation and Configuration November 2014