dSPACE recommends to use the DS821‑34 mm only in
combination with newer notebooks which provide a free
ExpressCard/34 slot. If you use them with older notebooks (for
example, which provide only ExpressCard/54 slots), your system
might crash when you boot your notebook. To solve this problem,
update the BIOS of your notebook.
It is highly recommended to use the DS821 Link Board
only in combination with the dSPACE CardSafe. For
details, refer to Using dSPACE CardSafe on page 65.
Limitations With Link Boards
The following limitations currently apply for the link boards DS814,
DS815, DS817, DS819, and DS821.
Objective
The DS819 and DS821 link boards are supported as of dSPACE
Release 5.2.
Required software
n You can install only up to eight DS817, or DS819 boards in one
host PC.
n Windows allows only one DS815. This limitation also applies to
DS815 boards which are installed in the host PC via a PCI-to-PC
Card adapter.
If you want to work with more than one expansion box, use the
DS817, DS819, DS821, or DS830.
n If you want to work with several boxes, you can use the DS830
MultiLink Panel as an alternative. With the DS830, you need to
install only one link board (PC) in the host PC. For further
information, refer to Connecting dSPACE Boxes to the Host PC via
DS830 on page 74.
Number of link boards (PC)
s
Connecting via Bus Interface
t
DS1103 Hardware Installation and Configuration November 2014
57
t
To Next Page
Loading...
Need help?
General
