PX20 Expansion Box Installation
You can install a PX20 desktop box in a 19’’ rack.
Objective
Mounting a PX20 Expansion Box in a 19'' Rack
The PX20 Expansion Box is available as either a desktop box or a
rack‑mount version. However, you can also install the desktop box in
a 19’’ rack.
Objective
n When the outer decorative cover of a PX20 is removed, its chassis
can be mounted in a standard 19’’ rack. There are five M5 threads
on either side of the chassis. The bolts should be as short as
possible to prevent short circuits inside the unit, and must not
protrude more than 5 mm (0.2") into the box. With common 19’’
racks, M5 x 6 bolts can be used.
n To prevent the system from overheating make sure that the
ventilation is not obstructed.
The plastic front cover can be snapped off and can be
replaced by a special version with rack handles, which is
available upon request.
Notes for mounting
s
PX20 Expansion Box Installation
t
DS1103 Hardware Installation and Configuration November 2014
49
t
To Next Page
Loading...
