Installing the DS1103
The DS1103 can be installed:
n in the host PC
n in an expansion box/AutoBox connected to the PC via Ethernet or
a bus interface
Objective
Information in this section
How to Switch Off a dSPACE System 37
How to Install the DS1103 38
How to Switch On the dSPACE System 41
Information in other sections
Safety Precautions for Installing and Connecting the
Hardware
17
How to Switch Off a dSPACE System
You must follow the instructions below.
Objective
To switch off a dSPACE system
1 Turn off all external devices connected to the dSPACE system.
2 Shut down the host PC and turn it off.
Do not switch off the expansion box while the host PC
is still running. This might lead to unpredictable errors.
3 Turn off the expansion box (if used).
The dSPACE system is ready for installing or removing hardware
components and connecting or disconnecting devices.
Result
HowTos
• How to Install the DS1103 on page 38
Related topics
Where to go from here
Method
s
Installing the DS1103
t
DS1103 Hardware Installation and Configuration November 2014
37
t
To Next Page
Loading...
