Removing the Hardware
dSPACE hardware is installed in the host PC and/or in the expansion
box.
Objective
Information in this section
How to Remove the Hardware from the Host PC 98
How to Remove Hardware from an Expansion Box 100
How to Remove the Hardware from the Host PC
The boards to be removed from your host PC depend on the
installation of the DS1103 PPC Controller Board.
Objective
n If the DS1103 is installed in an expansion box connected to the
host PC via a bus interface, the DS817 Link Board must be
removed. The DS815 and DS821 can simply be ejected from the
host PC.
n The DS1103 is installed in an expansion box connected to the host
PC via Ethernet, only the network cable of the expansion box
needs to be disconnected from the PC or the local area network.
Installation cases
n The system is switched off. For instructions, refer to How to Switch
Off a dSPACE System on page 37.
n Precautions are taken to avoid damage by high electrostatic
voltages. For details, refer to Safety Precautions for Installing and
Connecting the Hardware on page 17.
Preconditions
Where to go from here
s
Uninstalling the System
t
98
s
DS1103 Hardware Installation and Configuration November 2014
To Next Page
Loading...
Need help?
General
