To remove dSPACE boards
WA R NI NG
Hazardous voltages
Risk of electric shock and/or damage to the hardware
Before removing any board, make sure that:
n The power supply of the host PC and/or the expansion
box are switched off.
n No external device is connected to the dSPACE system.
1 Disconnect the host PC, the expansion box and all external devices
connected to them from the power supply.
2 Unplug any external devices or connector panels from the I/O
connectors of the DS1103.
3 Open the enclosure.
N O T I C E
Improper handling will damage the fan of the
board.
Only valid for boards up to board revision DS1103-07.
n Do not touch any components of the fan, neither
during operation nor when it has stopped.
n Do not apply pressure to the fan bearing during
installation and removal of the board.
4 Unscrew the triple bracket of the DS1103 or the bracket of the
link board (PC).
5 Remove the DS1103 and/or the link board (PC) from the slot.
6 Reinstall the original bracket(s) to cover the opening(s) at the rear
side of the enclosure.
7 Close the enclosure, reconnect the PC to the power supply, and
turn it on.
The host PC should boot as usual.
Result
Basics
• Safety Precautions for Installing and Connecting the Hardware on page 17
HowTos
• How to Switch Off a dSPACE System on page 37
Related topics
Method
s
Removing the Hardware
t
DS1103 Hardware Installation and Configuration November 2014
99
t
To Next Page
Loading...
Need help?
General
