dSPACE DS1103 - Problems When Setting up the TCP;IP Protocol; Problems with Peer-To-Peer Connection

To restore the missing BIOS setup of the slot CPU, contact dSPACE
Support for further instructions.
Remedy
Problems When Setting Up the TCP/IP Protocol
When you check the installation of the TCP/IP protocol with the ping
command, the following error messages may occur.
Error message Cause Remedy
Bad command or file
name
The TCP/IP protocol
has not been
installed properly.
Install the TCP/IP
protocol again.
The name specified is
not recognized as an
internal or external
command, operable
program or batch file
The TCP/IP protocol
has not been
installed properly.
Install the TCP/IP
protocol again.
Unable to contact IP
driver, error code x
found.
The TCP/IP protocol
has not been
installed properly.
Install the TCP/IP
protocol again.
Pinging 127.0.0.1
with x bytes of data:
Request timed out
The TCP/IP protocol
has not been
configured properly.
Check the
configuration of the
TCP/IP protocol. If
you are uncertain,
ask your system
administrator.
Troubleshooting
Problems with Peer‑To‑Peer Connection
You may encounter some problems when you set up a peer‑to‑peer
connection between your host PC and an expansion box.
Objective
Pinging 192.100.100.98 with 32 bytes of data:
Request timed out
Error message
s
Troubleshooting
t
216
s
DS1103 Hardware Installation and Configuration November 2014