To connect a panel to the DS1103
N O T I C E
Connecting external devices while the power supply
is switched on may damage the dSPACE hardware.
n Do not connect or disconnect any device while the
power supply is switched on.
n Turn off the host PC, the expansion box (if used), and
the external devices beforehand.
1 Plug the CP1103 or CLP1103 to the DS1103 and tighten the lock
screws. Take care not to mix up the connectors of the DS1103.
Connectors are installed correctly when ribbon cables are not
twisted and do not cross over each other. Furthermore, the
connectors are marked by labels P1A, P1B, etc.
2 Put templates on the panel. Turn the black clips on the panel
through 90 degrees to secure the templates to the panel.
Now you can:
n Connect devices to the panel. For detailed instructions, refer to
How to Connect External Devices to a Connector Panel
on page 95.
n Switch on the dSPACE system. Refer to How to Switch On the
dSPACE System on page 41.
Next steps
Basics
• Safety Precautions for Using Connector Panels on page 20
HowTos
• How to Connect External Devices to a Connector Panel on page 95
• How to Switch Off a dSPACE System on page 37
Related topics
How to Mount a Panel in a 19” Rack
The connector and LED panels are installed in a desktop box made
from aluminum profiles as a standard. They can optionally be
mounted in a 19’’ industry rack.
Objective
Method
s
Installing a Connector Panel
t
DS1103 Hardware Installation and Configuration November 2014
43
t
To Next Page
Loading...
Need help?
General
