If you encounter any problems during installation and
configuration:
n Check the Support section of our website.
See http://www.dspace.com/go/support.
n The FAQ section and application notes provide a lot of
useful information.
See http://www.dspace.com/go/FAQ.
n To stay up-to-date with information on possible
problems, you should periodically check the known
problem reports.
See http://www.dspace.com/go/ProblemReports.
If self-help does not solve the problem, contact dSPACE
Support and give them information about your dSPACE
environment and the problems you have. The best way to
do this is with the support request form provided on the
website at http://www.dspace.com/go/supportrequest, but
you can also send an e-mail or phone us. For details, refer
to Contacting dSPACE Support (
Software Installation
and Management Guide).
Installation problems
After you install and configure your system, you are ready to
implement a model – either via a Simulink model including blocks
from dSPACE’s Real‑Time Interface (RTI) or via a handcoded algorithm
– and download the corresponding application to your real‑time
hardware. ControlDesk Next Generation can be used to experiment
with your real‑time application. Refer to First Work Steps with a
dSPACE System.
Next steps
For information on connecting external devices of your application to
the dSPACE system, refer to Connecting External Devices to the
dSPACE System on page 93.
External devices
Basics
• Hardware on page 21
• Installing dSPACE Software ( Software Installation and Management Guide)
• Introduction to the DS1103 on page 21
• Software on page 22
Related topics
s
Installation and Configuration Overview
t
DS1103 Hardware Installation and Configuration November 2014
25
t
To Next Page
Loading...
Need help?
General
