You must first install the software before installing any hardware
component to the host PC and before connecting an expansion
box to it. For detailed instructions on installing the software, refer
to Installing dSPACE Software ( Software Installation and
Management Guide).
You need administrator rights to install dSPACE
software.
2. Check whether your hardware meets the requirements for
DS1103. Refer to Checking the System Requirements
on page 26.
3. Check if the default setting of the board must be changed. Refer
to Setting up the DS1103 on page 34.
4. Now you can install the hardware. Refer to How to Install the
DS1103 on page 38.
5. If the DS1103 is installed in an expansion box, connect the box to
your host PC. Refer to Connecting an Expansion Box to the Host
PC on page 53.
After you install your DS1103, you can configure it in the following
steps:
1. Set the connection mode and register your hardware.
2. Check if your platform is ready to run real-time applications.
3. The firmware of the DS1103 can be updated if you install a new
dSPACE Release.
Configuration sequence
s
Before You Start
t
24
s
DS1103 Hardware Installation and Configuration November 2014
To Next Page
Loading...
Need help?
General
