About these instructions
8 Service Instructions 755 A/756 A - 00.0 - 02/2019
Steps to be performed when operating the machine (sewing and
equipping)
Steps to be performed for service, maintenance, and installation
Steps to be performed via the software control panel
The individual steps are numbered:
First step
Second step
The steps must always be followed in the specified order.
Lists are marked by bullet points.
Result of performing an operation
Change to the machine or on the display/control panel.
Important
Special attention must be paid to this point when performing a step.
Information
Additional information, e.g. on alternative operating options.
Order
Specifies the work to be performed before or after a setting.
References
ï€ ï€ ï€ ï€ ï€ ï€¦ Reference to another section in these instructions.
Safety Important warnings for the user of the machine are specifically marked.
Since safety is of particular importance, hazard symbols, levels of
danger and their signal words are described separately in the chapter
Safety ( p. 11).
Location
information
If no other clear location information is used in a figure, indications of right
or left are always from the user's point of view.
To Next Page
Loading...
Need help?
General
