Endless zipper feed (optional)
Service Instructions 755 A/756 A - 00.0 - 02/2019 219
26.6 Setting the folder height when the zipper is cut
Proper setting
When the zipper is cut, the folder is lowered halfway down.
The distance between the half-lowered folder and the swung-out zipper
cutter is 5 mm.
Fig. 217: Setting the folder height when the zipper is cut
To set the height of the folder when the zipper is cut:
1. Select the menu Service > Machine test > Test step by step.
2. Sew until the zipper has been cut.
3. Loosen the screws (1).
4. Shift the holder (2).
• To move the folder closer to the zipper cutter: Push the holder (2)
downwards
• To move the folder further away from the zipper cutter: Push the
holder (2) upwards.
5. Tighten the screws (1).
Information
The closer the folder is positioned to the zipper cutter, the shorter the
zipper projection is at the next seam beginning.
(1) - Screws (2) - Holder
To Next Page
Loading...
Need help?
General
