Needle bar
44 Service Instructions 755 A/756 A - 00.0 - 02/2019
6.2.3 Changing the needle holder
Fig. 36: Changing the needle holder
To change the needle holder:
1. Remove the needles.
2. Loosen the screw (2).
3. Unscrew the needle holder (3) from the needle bar (1).
If necessary, turn off the needle bar.
4. Screw in the new needle holder until the screw (2) is centered in the
slotted hole of the needle bar (1).
5. Tighten the screw (2).
Order
Finish by checking the height of the needle bar ( p. 43).
(1) - Needle bar
(2) - Screw
(3) - Needle holder
To Next Page
Loading...
Need help?
General
