Table of Contents
Service Instructions 755 A/756 A - 00.0 - 02/2019 3
19.4.2 Setting the distance of the transport clamps to the folder
sole (motorized)........................................................................ 130
19.5 Setting the blowing of the piping strips ..................................... 132
19.6 Setting the transport clamp pressure........................................ 134
19.6.1 Setting the transport clamp pressure manually ........................ 134
19.6.2 Setting the programmable transport clamp pressure................ 135
19.7 Changing the toothed belt of the motorized transport clamp.... 135
20 Automatic corner knife station (straight pocket)................. 137
20.1 Adjusting the corner knives mechanically................................. 137
20.1.1 Setting the initial position of the corner knives ......................... 138
20.1.2 Testing the initial position of the corner knives manually.......... 139
20.2 Testing and adjusting the corner knives electrically ................. 142
20.3 Aligning the corner knife station with the seams....................... 145
20.4 Setting the angle of the corner knife incisions .......................... 146
20.5 Replacing corner knives ........................................................... 147
21 Automatic corner knife station (straight/slanted pocket)... 148
21.1 Adjusting the corner knives mechanically................................. 148
21.1.1 Setting the initial position of the corner knives ......................... 149
21.1.2 Setting the piercers................................................................... 150
21.1.3 Setting the corner knife inclination............................................ 151
21.1.4 Testing the initial position of the corner knives manually.......... 153
21.2 Testing and adjusting the corner knives electrically ................. 156
21.3 Aligning the corner knife station with the seams....................... 160
21.4 Setting the angle of the corner knife incisions .......................... 161
21.5 Replacing corner knives ........................................................... 162
22 Multi-functional corner knife station..................................... 163
22.1 Adjusting the corner knives manually ....................................... 163
22.1.1 Setting the initial position of the corner knives ......................... 164
22.1.2 Setting the piercers................................................................... 165
22.1.3 Setting the corner knife inclination............................................ 166
22.1.4 Testing the initial position of the corner knives manually.......... 167
22.2 Setting the speed and the end position damping
of the corner knives .................................................................. 171
22.2.1 Setting the speed...................................................................... 171
22.2.2 Setting the end position damping ............................................. 172
22.3 Testing and adjusting the corner knives electrically ................. 173
22.4 Aligning the corner knife station with the seams....................... 178
22.5 Setting the angle of the corner knife incisions .......................... 180
22.6 Replacing corner knives ........................................................... 181
22.7 Changing the reference switch on the corner knife support ..... 182
23 Marking lamps ........................................................................ 183
23.1 Setting the stationary marking lamps ....................................... 184
23.2 Setting the programmable marking lamp vertical (optional) ..... 185
24 Light barriers .......................................................................... 187
24.1 Setting the light barrier holder .................................................. 187
24.2 Aligning the light barriers .......................................................... 189
To Next Page
Loading...
Need help?
General
