Evinrude E-tec 75 HP - Recoil Starter Assembly

363
MANUAL STARTER
RECOIL STARTER REMOVAL
14
RECOIL STARTER
REMOVAL
Remove the clamp holding the oiling system wir-
ing harness.
Remove the three st arter housing screws and
washers.
Lift starter housing from outboard.
Remove three screws and r emove starter ratchet
from flywheel.
RECOIL STARTER
DISASSEMBLY
Pull the st arter rope out far enough to tie a slip
knot in t he ro pe. Remove t he e nd o f th e st arter
rope from the handle anchor and remove the han-
dle. Release the slip knot and ease the rope back
in until the rewind spring is fully unwound. If nec-
essary, remove the starter handle bracket from the
starter housing.
Remove th e rope g uide a nd pulley sup port from
the starter housing.
A WARNING
To prevent accidental starting while ser-
vicing, twist and remove all spark plug
leads.
1. Clamp
2. Starter housing screws (3)
002515
1. Ratchet 006483
2
1
2
2
1
A WARNING
Wear safety glasses while disassembling
and assembling manual starters because
of rewind spring tension.
1. Slip knot
2. Rope anchor
007853
1. Rope guide
2. Pulley support
007854
1
2
1
2