70
ENGINE MANAGEMENT MODULE (EMM)
EMM SERVICING
IMPORTANT: Software repla cement requires
the use of Bootstrap Tool, P/N 586551. Install tool
between engine and boat harness key/stop switch
connectors as instructed by update program.
EMM Transfer
EMM Transfer is used to save engine history data
when the EMM must be replaced.
Select EMM Data Transfer from the Utilities menu.
Select Perform Transfer From Memory and follow
the instructions provided with the program.
IMPORTANT: Whenever th e EMM is rep laced,
EMM timing must be synchronized to crankshaf t
position. Refe r to TIMING ADJUSTMENTS on
p. 113.
EMM SERVICING
IMPORTANT: If a n ew EMM i s b eing installed,
refer to EMM Transfer on p. 70.
Removal
Disconnect cooling hoses from EMM.
Disconnect J1-A, J1-B, and J2 connectors.
Remove three EMM re taining screws a nd wash-
ers. Remove EMM.
Remove EMM from behind oil tank bosses.
002383
1. Select EMM Data Transfer
2. Select Perform Transfer From Memory
008495
1. Cooling hose connections
2. EMM mounting screws
006476
006477
To Next Page
Loading...
