149
FUEL SYSTEM
FUEL COMPONENT SERVICING
7
Tighten scre ws in stages, starting wit h the lower
screw.
• First torque is 5 ft. lbs. (7 N·m).
• Second torque is 10 ft. lbs. (14 N·m).
• Final torque is 24 to 26 ft. lbs. (33 to 35 N·m).
Reconnect fuel injector electrical connectors.
Install the ignition co il assemblies. T ighten coil
screws to a torqu e of 60 to 8 4 in. lbs (7 to 9.5
N·m).
Install fuel manifolds. Refer to Fuel Manifold Ser-
vice on p. 145.
Intake Manifold Service
Removal
Disconnect vapor separator vent hose, main bear-
ing vent hose, a ir temperature sensor, crankshaft
position sensor, and throttle position sensor.
Use Ball So cket Remover To ol, P/N 342226, to
remove throttle link arm.
Remove throttle bo dy screws a nd th rottle body
assembly.
Remove gasket from throttle body.
Remove screws and reed plate assembly from the
crankcase.
Tighten Screws in Stages 006562
1. Link arm
2. Throttle body screws
002499
1. Screws 002503
To Next Page
Loading...
