37
ROUTINE SERVICE
LUBRICATION
2
LUBRICATION
Steering System
Grease the stainless steel output end of the steer-
ing cable with Triple-Guard grease.
Use an ap propriate cleaning solvent to remove
corrosion and dirt from output end of cable before
coating it wit h gre ase. Make sure wip er nu t is
installed and not damaged.
Tiller Handle
Lubricate the tiller ha ndle grease fitting s with Tri-
ple-Guard grease.
A WARNING
Failure to regrease as recommended
could result in steering system corrosion.
Corrosion can affect steering effort, mak-
ing operator control difficult.
1. Steering cable
2. Wiper nut
DR29546
1. Tiller handle fittings – Standard handle 008196
1. Tiller handle fittings – Long handle 008197
To Next Page
Loading...
