71
ENGINE MANAGEMENT MODULE (EMM)
EMM SERVICING
4
Installation
Installation is the revers e of removal. Pay close
attention when performing the following tasks.
Make sure isolator mounts are placed in slots in of
EMM case. Slide EMM into position.
Apply Nut Lock t o t hreads o f EMM ret aining
screws. Tighten to a torque of 30 to 42 in. lbs. (4
to 5 N·m).
Install harn ess connectors and cooling h oses.
Secure hoses with tie straps.
1. Isolator mounts 006478
To Next Page
Loading...
