Fore Systems ES-2810 - Changing the Setup of the Port; Purpose; Using the Mouse

FORE Systems ES-2810 Ethernet Switch User's Manual
3 - 27
Standard Configuration
Standard
Configuration
3.16 Changing the Setup of the Port
3.16.1 Purpose
You can configure the port to operate in different ways, according to your network’s require-
ments:
• Change the port state
• Select the auto-negotiation mode
• Change each port to half or full duplex
(If auto-negotiation is not enabled)
• Specify the speed of the port
(If auto-negotiation is not enabled)
• Change the forwarding mode of the port
• Change the flow control setting of the port
• Specify the spanning tree
3.16.2 Using the Mouse
There are two ways to access the Port Setup window:
• Double-click the port
• Right-click on the port, and click Port Setup