Fore Systems ES-2810 - Installing a Module; Removing a Module

FORE Systems ES-2810 Ethernet Switch User’s Manual
1 - 13
Introduction to the ES-2810
Introduction to the ES-
2810
1.6.4 Installing a Module
To install a module:
1. If the switch is already operational, disconnect it from the main power supply.
2. Follow the instructions in “Avoiding damage to the circuit board” above.
3. Unscrew the screws of the plate covering the slot on the front of the switch. Save
these screws and plate.
4. Insert the module into the slot. Place your thumbs just beneath the screws on the
front panel of the module and push in the module. Secure it using the retaining
screws.
1.6.5 Removing a Module
To remove a module:
1. If the switch is already operational, disconnect it from the main power supply.
2. Follow the instructions in “Avoiding damage to the circuit board” above.
3. Unscrew the screws securing the module.
4. Pull the module gently to disengage the connectors fully from the socket on the
motherboard. Slide the module out completely.
5. Cover the empty module port with the plate and secure using the screws.