1 - 18
FORE Systems ES-2810 Ethernet Switch User’s Manual
Introduction to the ES-2810
1.9 Power Up
1.9.1 Powering Up the Switch
Follow these steps to power up the switch:
1. Push the female end of the power cable into the main socket (in the rear panel);
plug the other end into the power supply outlet.
2. Make sure that the Power LED (on the front panel) is green.
If it isn’t green, make sure that the power outlet is working correctly (switched
on). If the power outlet is on and the Power LED is not green, then there is a fault
within the switch and you must contact your dealer.
3. Verify that an LED is lit for each of the front panel ports where a powered on device
is connected.
1.9.2 Start-up Procedure
Immediately after power-up, the following should happen during start-up:
If the Status LED remains red, then the switch has not started successfully. Try to restart it; if
the switch does not start, contact your dealer.
Look at the other front panel LEDs during start-up and check that they are operating correctly.
Table 1.10 -
LED Indications During Start-up
Stage STATUS LED... Then the switch...
1 Is red Is starting up
2 Turns to steady green Has started successfully
To Next Page
Loading...