Fore Systems ES-2810 - Changing the Forwarding Mode on a Port; Changing the Flow Control on a Port

3 - 32
FORE Systems ES-2810 Ethernet Switch User's Manual
Standard Configuration
3.18.5 Changing the Forwarding Mode on a Port
To change the forwarding mode to be used on a port:
1. Click the port you want to change.
2. Select Port Setup.
3. Click Port Mode.
4. In Switch Forwarding Mode, click the forwarding mode you want.
Default uses the same forwarding mode as specified in Device Setup.
5. Click OK.
3.18.6 Changing the Flow Control on a Port
Flow control prevents the loss of frames during busy periods. To change the flow mechanism
on a port:
NOTE
This feature is over-ridden by disabling the flow
control setting in Device Setup>Switching.
1. Click the port you want to change.
2. Select Port Setup.
3. Click Port Mode.
4. In Flow Control, click the flow control you want.
Default uses the same flow control as specified in Device Setup.
5. Click OK.