Fore Systems ES-2810 - Enabling ATM ELAN; Monitoring STP Groups

4 - 10
FORE Systems ES-2810 Ethernet Switch User's Manual
Advanced Configuration
4.4.4 Enabling ATM ELAN
This must be enabled when mapping VLANs in an Ethernet switch to ELANs in an ATM
switch. To enable this:
1. Select VLAN/Routing Setup.
2. Click Advanced>ATM ELAN.
3. Check Enable.
4. Click OK.
4.4.5 Monitoring STP Groups
To monitor all spanning tree groups, other than those on the Management VLAN, establish a
telnet session:
1. Use the procedure described in “TFTP” on page 3-17 to start a telnet session
2. Click Monitoring>STP.
3. Select either Port or Bridge.
4. Select a VLAN from the list. All the Port or Bridge details are displayed.