1 - 10
FORE Systems ES-2810 Ethernet Switch User’s Manual
Introduction to the ES-2810
1.5.3 Rack Requirements
Install the switch in a standard rack in accordance with IEC 297 (or similar); if the minimum
outside measurements of the rack are 600 x 600mm (23.5 x 23.5inches), you must allow
190mm (7.5inches) of space at the rear.
1.5.4 Mounting Kit
The switch is delivered with a kit to attach it to a standard 19-inch equipment rack (with side
support rails). The kit contains two mounting brackets and four screws (for attaching the
brackets to the sides of the switch).
1.5.5 Tools Required for Positioning in a Rack
In addition to the mounting kit, you need the following items to mount the switch in a rack:
• Standard 19-inch rack with side support rails.
• 3 mm screwdriver.
• Customer-supplied screws for securing the switch in the rack.
Mounting screws are not provided because the required sizes may vary from rack
to rack.
To Next Page
Loading...