Fore Systems ES-2810 - Disabling Auto-Negotiation; Changing Duplex Mode; Changing the Port Speed

FORE Systems ES-2810 Ethernet Switch User's Manual
3 - 31
Standard Configuration
Standard
Configuration
3.18.2 Disabling Auto-negotiation
To disable auto-negotiation, and reset the speed to the values specified in Speed:
1. Click the port you want to disable auto-negotiation.
2. Select Port Setup.
3. Click Port Mode.
4. Click Enable Auto-negotiation.
If there is a check mark in the box, the port automatically detects the line-speed
and duplex setting. If the box is empty, auto-negotiation is disabled and the port
uses the values specified in Duplex and Speed.
5. Click OK.
3.18.3 Changing Duplex Mode
To change the port’s duplex mode (when auto-negotiation is disabled):
1. Click the port you want to change.
2. Select Port Setup.
3. Click Port Mode.
4. Click Half Duplex or Full Duplex.
Half allows either transmission or receipt of the data and Full allows both
transmission and receipt of the data.
5. Click OK.
3.18.4 Changing the Port Speed
To change the speed a port accepts data (when auto-negotiation is disabled):
1. Click the port you want to change.
2. Select Port Setup.
3. Click Port Mode.
4. Click Speed 10 or Speed 100.
10 limits data entering to 10Mbps and 100 allows data speeds up to 100Mbps.
5. Click OK.