Fore Systems ES-2810 - Page 21

FORE Systems ES-2810 Ethernet Switch User’s Manual
i
Preface
Preface
This manual provides the necessary information to install the FORE Systems ES-2810 Ethernet
switch. Also included is general product, network configuration, and software administration
information. This manual is for users with various levels of experience.
If you have any questions or problems with the installation, please contact FORE Systems’
Technical Assistance Center (TAC) using the information on page ii.
Chapter Summaries
Chapter 1 - Introduction to the ES-2810 -
Provides an overview of the ES-2810 switch and
installation procedures for the switch and its modules.
Chapter 2 - FORE Stack View -
Provides an overview of the Stack View network manage-
ment software for the ES-2810.
Chapter 3 - Standard Configuration -
Provides information on doing a standard configura-
tion of the ES-2810.
Chapter 4 - Advanced Configuration -
Provides information on doing an advanced configu-
ration using virtual LANs (VLANs).
Chapter 5 - Managing the Switch -
Provides information on managing the ES-2810 using the
Stack View network management software.
Chapter 6 - Technical Specifications
- Provides physical, power and performance specifica-
tions for the ES-2810 and its modules.
Chapter 7 - Console Port Use and Troubleshooting
- Provides information about using the
switch’s console port for local management and maintenance and a troubleshooting checklist
for the ES-2810.
Appendix A - Concepts in Switching
- Provides a basic overview of switching concepts
including forwarding modes, flow control, filtering, IP, etc.