Fuji Xerox DocuCentre SC2022

10 Changing the Machine Settings
237
10.8.5 [Status LED (Blue)]
Specify whether to enable the blue blinking feature of the Status LED on the operator panel.
Refer
• For details about the Status LED, see "Operator Panel (P.19)."
10.8.6 [Power Saver]
Set the amount of time until the machine enters the power saver mode.
Refer
• For details about the power saver mode, see "Power Saver Mode (P.59)."
[Low Power Timer]
Set the amount of time until the machine enters the low power mode.
[Sleep Timer]
Set the amount of time from low power mode until entering sleep mode.
10.8.7 [Timers]
Configure the timer settings.
[Auto Clear]
Select the amount of time until the machine returns to the [Home] screen when the machine is not operated for
a certain period of time.
[Fault Timeout]
Specifies the amount of time the machine waits before clearing an error message and returning to the [Home]
screen. This setting is used for an error not requiring users' operation to clear.
10.8.8 [Units]
Select the default measurement unit of the numeric value displayed on the operator panel.
Note
• The default setting varies depending on other settings, such as [Country/Region] and the size of the document.
10.8.9 [Original Size Detected]
Specify the size of document to be automatically detected when the machine is set to detect the size of
documents.
[Original Size Settings]
Specify the kind of the paper size to be automatically detected.
[A/B Series (8K/16K)]
A/B series (8K/16K) documents are automatically detected.