10 Changing the Machine Settings
265
10.13.2 [PDF Settings]
Configure the machine settings that only affect PDF files.
[Quantity]
Specify the number of copies to print.
[2-Sided]
Specify whether to print on both sides of a sheet of paper. For two-sided printing, specify whether the printouts
are bound at the long edge or short edge.
[Print Mode]
Select the print mode.
[Normal]
Use this mode for documents with normal sized characters.
[Fine]
Use this mode for documents with small characters or thin lines, or documents printed using a dot-matrix
printer.
[High Speed]
Prints with higher speed than the [Normal] mode, but with lower quality.
[PDF Password]
Set the password used to print PDF files protected by a password.
[Collation]
Specify whether to print out the file page by page or set by set when printing multiple number of copies of PDF
files.
[Output Size]
Specify the paper size.
[Layout]
Select the output layout.
[1-Up]
Prints a document in the layout specified by the machine.
[Off (No Scaling)]
Prints in the same size as a document.
[Booklet Creation]
Prints on both sides of a sheet of paper bound by the edge.
[2-Up]
Prints two pages on one side of a sheet of paper.
[4-Up]
Prints four pages on one side of a sheet of paper.
[PDF Default Color]
Select the color mode.
To Next Page
Loading...
