User Guide
264
[Font Size]
Specify the font size for scalable typographic fonts.
[Font Pitch]
Specify the font pitch for scalable mono spaced fonts. Font pitch refers to the number of characters printed in
one horizontal inch.
[Form Line]
Specify the number of lines in a page. The amount of space between lines are specified based on the [Output
Size] and [Original Orientation] settings. Specify the paper size and the orientation beforehand.
[Quantity]
Specify the number of copies to print.
• For a specific job, set the quantity from the print driver. Values selected from the print driver always override values
selected from the operator panel.
[Image Enhance]
Specify whether to enable the image enhance feature. Enabling this feature makes the boundary line between
black and white smoother to decrease jagged edges and enhance the visual appearance.
[Hex Dump]
Specify whether to help to isolate the source of a print job problem. With this setting enabled, all data sent to
the machine is printed in hexadecimal and character representation. Control codes are not executed.
[Draft Mode]
Specify whether to save toner when printing. The print quality is lower when compared to normal printing.
[Line Termination]
Specify whether to add line termination commands.
[Off]
The line termination command is not added.
CR=CR, LF=LF, FF=FF
[Add LF]
The LF command is added.
CR=CR-LF, LF=LF, FF=FF
[Add CR]
The CR command is added.
CR=CR, LF=CR-LF, FF=CR-FF
[CR-XX]
The CR and LF commands are added.
CR=CR-LF, LF=CR-LF, FF=CR-FF
[Output Color]
Select the color mode.
[Ignore Form Feed]
Specify whether not to print the blank pages without any images, and to print only the pages with images.
To Next Page
Loading...
