4 Printing
97
4.6 Printing on Envelopes
This section describes how to print using the PCL driver on envelopes loaded in Tray 5 (bypass).
1.
Load envelopes in Tray 5 (bypass).
• You can load envelopes only in Tray 5 (bypass).
• Use only freshly unpacked new envelopes.
If the envelopes are not loaded right after they are unpacked, they may curl. To avoid jams, press the envelopes firmly
to flatten them as shown in the illustration before loading the envelopes.
• Do not load different sized envelopes at the same time.
• The maximum height of envelopes that can be loaded in Tray 5 (bypass) is about 10 mm (0.39").
• If envelopes are not fed correctly, curl the edge of the envelopes as shown in the following illustration. It is
recommended that the amount of the curl should be 2 or 3 mm (0.08 or 0.12"). The area of the curl should be 8 to 10
mm (0.32 to 0.39") from the top edge of the envelopes. Do not curl the envelopes too much or make a crease.
2 - 3 mm
(0.08 - 0.12")
8 - 10 mm (0.32 - 0.39")
To Next Page
Loading...
