Preliminary steps
▶
"Suspending BitLocker functionality" on page 65
.
▶
"Shutting down the server" on page 45.
▶
"Disconnecting the power cord" on page 46.
▶
"Getting access to the component" on page 47.
▶
"Removing the air duct" on page 58.
▶
"Removing the fan holder" on page 60.
Removing the front panel cage
▶
Remove the front panel cage, see "Removing the front panel cage" on
page 347.
Installing the front panel on QRL
▶
Install the front panel on QRL, see "Removing the front panel on QRL" on
page 367.
Installing the ID card holder
▶
Install the ID card holder, see "Removing the ID card holder" on page 374.
Installing the third 2.5-inch HDD backplane
▶
Install the third backplane, see "Installing a 2.5-inch HDD backplane" on
page 187.
▶
Connect the cables to the third backplane, see "Connecting a 2.5-inch HDD
backplane" on page 188.
▶
Connect the power cable from the third backplane to connector "PWR3" on
the system board.
▶
If applicable, install the SAS expander board, see "Installing the SAS
expander board" on page 193.
▶
Connect the SAS cable to the corresponding controller or to the SAS
expander board.
Hard disk drive (HDD) / solid state disk (SSD)
192 Upgrade and Maintenance Manual RX2520 M5
To Next Page
Loading...
