Gilera GP 800 i.e. - Page 215

- Install the coolant temperature sensor with the
washer and tighten to the prescribed torque.
CAUTION
FAILURE TO OBSERVE THE TIGHTENING
TORQUE CAN DAMAGE THE SENSOR.
Locking torques (N*m)
Coolant temperature sensor 21 ÷ 23
- Fit the spark plugs and tighten them to the prescribed torque.
Locking torques (N*m)
Spark plug 12 ÷ 14
- Fit the rpm timing sensor and tighten to the pre-
scribed timing.
Locking torques (N*m)
Rpm timing sensor screw 7.5 ÷ 8.5 Nm
- Insert the timing control belt on the crankshaft
according to the initial direction of rotation.
- Install the tensioner shoe with its spacer, tight-
ening the bolt to the prescribed torque, using the
recommended product.
Recommended products
Loctite 243 Medium strength threadlock
Loctite 243 medium-strength threadlock
Locking torques (N*m)
Tensioner sliding block fixing screw: 10 - 14
- Fit the pins and the rocking levers operating on
the transmission side.
- Lubricate the two rocking levers through the
holes at the top.
GP 800 i.e. Engine
ENG - 65