- With the references aligned, operate on the driv-
ing pulley to turn the crankshaft until, the rear
cylinder timing reference mark «1» on the flywheel
is aligned to the crankcase reference mark.
- Fit the tone wheel, the timing system gear with
the chain and align the reference marks.
- Once the reference marks are aligned as indica-
ted with the reference marks on the valve cam cap,
tighten the screw with the washer to the prescribed
torque.
Locking torques (N*m)
Timing system gear on camshaft screw 12 ÷ 14
- Place the tightener cursor in the rest position,
keeping the retain tab pressed.
GP 800 i.e. Engine
ENG - 67
To Next Page
Loading...
