GW Instek GDM-906 Series - Page 294

GDM-906X Series User Manual
294
[SENSe:]FRESistance:NULL:VALue:AUTO
Sets the relative value auto on/off for 4-wire resistance measurement.
Parameter: 0 | 1 | ON | OFF
Example: SENS:FRES:NULL:STAT ON
SENS:FRES:NULL:VAL:AUTO ON
The unit automatically sets the 1st count of measurement as null value.
[SENSe:]FRESistance:NULL:VALue:AUTO?
Returns the null value auto state of 4-wire resistance measurement.
[SENSe:]FRESistance:RANGe
Sets the 4-wire resistance measurement range.
Parameter: Range(<NRf> | MIN | MAX | DEF)
Example: SENS:FRES:RANG 10e3
Sets the 4-wire resistance range to 10kΩ.
[SENSe:]FRESistance:RANGe?
Returns the 4-wire resistance measurement range.
[SENSe:]FRESistance:RANGe:AUTO
Sets the 4-wire resistance Auto-range settings on, off or once.
Parameter: 0 | 1 | ON | OFF | ONCE
Example: SENS:FRES:RANG:AUTO ON
Turns Auto-range on for 4-wire resistance measurement.
[SENSe:]FRESistance:RANGe:AUTO?
Returns the 4-wire resistance Auto-range setting.
Return parameter: 0 | 1, 0=OFF, 1=ON
[SENSe:]FRESistance:RESolution
Sets the 4-wire resistance measurement resolution. The resolution depends
on the rate and range settings.
Parameter: Resolution(<NRf> | MIN | MAX | DEF)
Example: SENS:FRES:RES 0.01
Sets the 4-wire resistance resolution to 0.01
[SENSe:]FRESistance:RESolution?
Returns the 4-wire resistance resolution.
[SENSe:]FRESistance:TRIGger:DELay
Sets the trigger delay time that minimum step is microseconds of 4-wire
resistance measurement.
Parameter: <NRf> (0 ~ 3600 s) | MIN | MAX | DEF
Example: SENS:RES:TRIG:DEL MIN
Sets the trigger delay time to 0s of 4-wire resistance measurement.