Harris Corporation Constellation™
Network Management Submenu 6-7
IP COMMUNICATION
STACK AND IP
APPLICATIONS
Static Routing Tables
Seven static routing tables can be added/removed from/to the RIP tables.
Table
6-6
is an explanation for routing table 1.
The address 255.255.255.255 disables the static entry.
RIP ON
NETCOM IF
DISABLE/
ENABLE
The default value is Enable. This command
enables/disables the RIP protocol on the Netcom
IP interface.
Select Enable unless you would like to isolate this
radio from the rest of the Harris radios on the
network, RIP-wise. Those who do not clearly
understand how the RIP functions should not try
to change this parameter.
RIP ON
ETHERNET IF
DISABLE/
ENABLE
The default value is Enable. This command
enables/disables the RIP protocol on the Ethernet
IP interface.
Select Enable unless you would like to isolate the
OEM equipment connected to the Ethernet port
from the Harris radios on the network, RIP-wise.
Those who do not clearly understand how the RIP
functions should not try to change this parameter.
Table 6-6: Ethernet IP interface
IP ROUTING
Submenu
Selection Explanation
IP Route 1
Address
xxx.xxx.xxx.xxx
IP address of the subnetwork to be
reached
IP Route Mask 1 xxx.xxx.xxx.xxx
IP mask of the subnetwork to be
reached
Next IP Router 1 xxx.xxx.xxx.xxx
Router to which the IP packet to be sent
in order to reach “IP Router 1 Address”
Table 6-5: RIP (continued)
IP
ROUTING
Submenu
Selectio
n
Explanation
To Next Page
Loading...
