Harris Corporation Constellation™
Safety Warnings 1-3
INTRODUCTION
for the improper performance of the equipment,
damage to the equipment, or injury to personnel
caused by improper practices.
To prevent equipment damage and shock hazard
caused by lightning, antenna installation and the
grounding system must comply with NEC or IEC
standards, and local regulatory requirements.
The following general safety precautions must be observed at all times.
• Heed all warning labels that are permanently affixed to the equipment.
Failure to heed warnings can result in serious injury to the equipment
and/or user.
• Observe all laser, optical, and RF precautions.
• Observe all electrical precautions.
• Verify that the grounding configuration complies with local code
practice and requirements.
Personal Safety
RADIATION-FREQUENCY RADIATION HAZARD
Do not open waveguide with RF power on.
Do not connect power to the radio assembly
unless the transmitter is properly terminated. The
transmitter is terminated when its output is
connected to the antenna, to test equipment, or to
a dummy load.
Only properly trained personnel should operate
this equipment.
To Next Page
Loading...
