Constellation™ November 2003
3-36 Installation and Commissioning
If the signal level is too high for antenna alignment, the far-end Transmitter
could be set to ATPC low power (about 10 dB lower than nominal high power
setting). See Keypad menu, Appendix B.
CONFIGURATION > SYSTEM > TX ATPC > DISABLE LOW
If the signal level is still too high, a pad can be temporarily added at the
Receiver input.
1. Perform loopback tests (through the Keypad) (
Chapter 4
).
2. Perform BER tests from the Keypad.
PERFORMANCE > TRIBUTARY
To Next Page
Loading...
