3 UCN Status Displays
3.4 Display Operation
198 HPM High-Performance Process Manager Service R688
Honeywell December 2020
AUTO CHECKPT Target
Selection of the AUTO CHECKPT command target invokes additional targets at the bottom of the
display to change the Checkpointing state of the UCN or of the UCN device chosen by its status box as
shown in the following figure.
Figure 100 UCN Status Display – AUTO CHECKPT Target Selected
Not applicable for NIM
The AUTO CHECKPT target functions are not applicable when a NIM is chosen on the UCN Status
display.
To Next Page
Loading...
Need help?
General
