Honeywell HPM - LOAD;SAVE RESTORE Target; Figure 110 HPM Status Display - LOAD;SAVE RESTORE Target Selected

3 UCN Status Displays
3.5 HPM Status Displays
R688 HPM High-Performance Process Manager Service 217
December 2020 Honeywell
LOAD/SAVE RESTORE Target
Selection of the LOAD/SAVE RESTORE command target on the HPM Status display as shown in the
following figure invokes additional targets at the bottom of the display to either load the personality
program, restore the database, or save the database for the HPMM or IOP chosen by its status box.
Figure 110 HPM Status Display – LOAD/SAVE RESTORE Target Selected