Honeywell HPM User Manual

3 UCN Status Displays
3.4 Display Operation
R688 HPM High-Performance Process Manager Service 199
December 2020 Honeywell
AUTO CHECKPT display targets
The command targets at the bottom of the display in Figure 100 perform the functions defined in the
following table.
Table 28 UCN Status Display – AUTO CHECKPT Target Selected
Target
Function
UCN CKPT ENABLE
Enables automatic Checkpointing of all the UCN devices.
The command is executed by selecting the ENTER target.
UCN CKPT INHIBIT
Disables automati Checkpointing of all the UCN devices.
The command is executed by selecting the ENTER target.
DEV CKPT ENABLE
Enables automatic Checkpointing of the UCN device
chosen by its status box. The command is executed by
selecting the ENTER target.
DEV CKPT INHIBIT
Disables automatic Checkpointing of the UCN device
chosen by its status box. The command is executed by
selecting the ENTER target.
CANCEL
Clears the UCN CKPT ENABLE, UCN CKPT INHIBIT, DEV
CKPT ENABLE, DEV CKPT INHIBIT, and ENTER
command targets.
ENTER
The ENTER target must be selected for the chosen AUTO
CHECKPT function to be executed.

Honeywell HPM Specifications

General

Brand	Honeywell
Model	HPM
Category	Network Hardware
Language	English