3 UCN Status Displays
3.8 IOP Detail Status Displays
274 HPM High-Performance Process Manager Service R688
Honeywell December 2020
ENABLE CALIBRATN target
When the IOP is in the Idle or Idle/Soft Failure state, and not being calibrated, as indicated by a
calibration bit resident in the IOP, an ENABLE CALIBRATN target appears, indicating that calibration
can be initiated as shown in the following figure.
Figure 155 High Level Analog Input IOP Detail Status Display – ENABLE CALIBRATN
Target Selected
To Next Page
Loading...
Need help?
General
