Honeywell touchpoint Pro - Page 236

MAN0923_Issue 3_04/15 Touchpoint Pro
Operating Instructions
236
20. Appendix 7 - Logged events and
where they are displayed
Event Comment
Displayed
Specic
Channel Type
(if applicable)
Input
Details
screen
Output
Details
screen
Active
Events
screen
Inputs /
Outputs
screen
PSU Channel Modified One of the Status input channels
has been modified
PSU Decommissioned One of the Status input channels
has been removed
Pwd for Accept button Disabled
by UI
Password settings changed
Pwd for Accept button Enabled
by UI
Password settings changed
Pwd for Reset button Disabled
by UI
Password settings changed
Pwd for Reset button Enabled
by UI
Password settings changed
Rate Alarm
✔ ✔ ✔
mA, mV
Rate Alarm Acknowledged mA, mV
Rate Alarm Cleared mA, mV
Redundant CCB active, Master
failed
Master CCB has failed and the
redundant CCB has taken over
control of the system
✔
Redundant CCB Failure TBC
Redundant CCB successfully
replaced
Relay Output Error TBC ROM
Relay Output Error Cleared ROM
Remote Input Active If DIM channel is active and, DIM is
participating in Remote Interactions.
✔ ✔
DIM
Remote Input Cleared DIM
Reset Button Password Setting
Modified
The Reset button on the Touchpoint
Pro front panel can optionally be
password protected – the setting
has been changed
Ring {0} Fault 0 will be replaced by A or B.
✔
Ring {0} Fault Acknowledged 0 will be replaced by A or B
Ring {0} Fault Acknowledged at 0 will be replaced by A or B
Ring {0} Fault at CCB 0 will be replaced by A or B.
✔
Ring {0} Fault at CCB
Acknowledged
0 will be replaced by A or B
Ring {0} Fault at CCB Cleared 0 will be replaced by A or B
Ring {0} Fault between Controller 0 will be replaced by A or B