Honeywell touchpoint Pro - Page 235

MAN0923_Issue 3_04/15 Touchpoint Pro
Operating Instructions
235
20. Appendix 7 - Logged events and
where they are displayed
Event Comment
Displayed
Specic
Channel Type
(if applicable)
Input
Details
screen
Output
Details
screen
Active
Events
screen
Inputs /
Outputs
screen
mV Configuration State Inhibit Channel is in Inhibit because the
module is being configured
mV
mV Configuration State Inhibit
cleared
mV
mV Fault Recovery Inhibit Channel is in inhibit because a
fault recovery delay time has been
configured
mV
mV Fault Recovery Inhibit
cleared
mV
mV module inhibited channel TBC mV
mV module Inhibited channel
Cleared
mV
mV User Inhibit Channel has been inhibited by the
user
mV
mV User Inhibit Cleared mV
New I/O Channel added All
New I/O Module detected
✔
Open Circuit TBC
✔
mV
Open Circuit Cleared mV
Output Active ROM channel output active
✔
ROM
Output Active Forced ROM channel output has been
forced to activate
ROM
Output Deactive Forced ROM channel output has been
forced to deactivate
Output Forced ROM channel output has been
forced to activate
✔
ROM
Output Verification Error TBC
Output Active Force Cleared ROM
Output Cleared ROM
Output Deactive Force Cleared ROM
Output Force Cleared ROM
Output Verification Error Cleared
PC Config SW Login Logged when user logs in from PC
PC Config SW Logout Logged when user logs out from PC
Peak Hold When actual gas concentration
value rises above the configured
maximum gas range
✔ ✔ ✔
mA, mV
Peak Hold Active TBC