MAN0923_Issue 3_04/15 Touchpoint Pro
Operating Instructions
234
20. Appendix 7 - Logged events and
where they are displayed
Event Comment
Displayed
Specic
Channel Type
(if applicable)
Input
Details
screen
Output
Details
screen
Active
Events
screen
Inputs /
Outputs
screen
UI SW Update Logged when local HMI is updated
Local HMI Functional Logged when Local HMI System
Status screen is shown (this
indicates Local HMI is functional)
Local HMI Login Logged when user logs in from HMI
Local HMI Logout Logged when user logs out from
HMI
Local HMI OFF TBC
Local HMI ON TBC
LTEL Alarm
✔ ✔ ✔
mA
LTEL Alarm Acknowledged mA
LTEL Alarm Cleared mA
mA Configuration State Inhibit Channel is in Inhibit because the
module is being configured
mA
mA Configuration State Inhibit
cleared
mA
mA Fault Recovery Inhibit Channel is in inhibit because a
fault recovery delay time has been
configured
mA
mA Fault Recovery Inhibit
cleared
mA
mA module inhibited channel mA
mA User Inhibit Channel has been inhibited by the
user
mA
mA User Inhibit cleared mA
Modbus Update Logged when modbus application is
updated
Module Configuration Modified
Module Fault Acknowledged for All
Module Fault Cleared for All
Module Fault for All
Module ID assigned
Module Inhibit Cleared
Module Removed
Module Replaced
mV Auto Inhibit mV channel has been configured
but not yet calibrated
mV
mV Auto Inhibit cleared mV
To Next Page
Loading...
