Honeywell touchpoint Pro User Manual

MAN0923_Issue 3_04/15 Touchpoint Pro
Operating Instructions
85
6. Commissioning
6.9.3 Editing a Congured Channel
Note: When you enter the System Setup menu, a conguration timeout is active separate to the user login
timeout. If no values are sent to the system for 20 minutes, you will be logged out of conguration. Any
changes that have already been sent to the system will be retained, but any that have been made on screen
but not yet sent to the system will be lost. It may be necessary to return to the System Setup screen and set
the module to normal state.
Toeditanalreadyconguredchannel:
1. If not already logged in, login with a valid administrator level user name
2. From the System Status screen select the Extras icon then System Conguration
3. Re-enter the password and press Login
4. Select System Setup
5. The screen will show the system setup tree listing of all installed I/O modules and Control
Centre Board(s)
6. Press the + beside each module to expand and show the four channels of that module
7. Select the required channel, press the Menu icon and select Edit Conguration
8. Select the screen that you want to edit (refer to the previous sections)
9. EntertherequiredvaluesintheeldNew Value and press Send
10. The system will return the new value, press Accepttoconrm
11. If required, select another screen to edit, otherwise close the menu window
6.9.4 Removing an I/O Module
It is good engineering practice to remove modules from the software before physically removing them from
the Touchpoint Pro, even if you consider the module(s) to be unserviceable or beyond repair.
To remove a module:
1. If not already logged in, login with a valid administrator level user name
2. From the System Status screen select the Extras icon then System Conguration
3. Re-enter the password and press Login
4. Select System Setup
5. The screen will show the system setup tree listing of all installed I/O modules and Control Centre
Board(s)
6. Select the required channel, press the Menu icon and select Edit Conguration
7. Select Remove Module,andconrmbyselectingYes,
8. Press OK.
9. If required, select another screen to edit, otherwise close the menu window

Honeywell touchpoint Pro Specifications

General

Brand	Honeywell
Model	touchpoint Pro
Category	Control Systems
Language	English