121
Chapter 6, Call Processing Subsystem
Using the Call Processing Subsystem
Generalized Procedures Using the Call Processing Subsystem
For general procedures for using the Call Processing Subsystem, see the following
sections:
• "Conditioning the Test Set for Call Processing" on page 141
• "Configure the Test Set" on page 142
• "Turn On The Test Set’s Control Channel" on page 143
• "Register a Mobile Station" on page 144
• "Page a Mobile Station" on page 145
• "Handoff a Mobile Station to a New Voice Channel" on page 147
• "Release A Mobile Station" on page 147
• "Change the Transmit Power Level of a Mobile Station" on page 148
• "Originate a Call from a Mobile Station" on page 149
• "Send an Alert Order to a Mobile Station" on page 150
• "Changing the Content of a Message Field" on page 242
• "Selecting The Message Content Generation Method" on page 239
• "To Make an RF Sensitivity Measurement" on page 248
• "To Make an FM Hum and Noise Measurement" on page 249
To Next Page
Loading...
