HP 8920A - TESTS (IBASIC Controller); The TESTS (IBASIC Controller) Screen

544
S:\HP892XX\USRGUIDE\manual\testscrn.fb
Chapter 22, Tests Screen
TESTS (IBASIC Controller)
TESTS (IBASIC Controller)
Figure 142 The TESTS (IBASIC Controller) Screen
The IBASIC controller is used to run IBASIC programs. This screen is also used
as a stand-alone IBASIC computer. See the Instrument BASIC documentation for
information about writing your own tests for the Test Set.
If you need to perform a simple IBASIC operation, such as a SAVE or GET
function, you can enter commands one at a time. To do this, access the
TESTS (IBASIC Controller) screen and use the knob to enter commands.
Refer to the Programmer’s Guide for information about using the TESTS
(IBASIC Controller) screen to write and store your own tests.
tstibasc.wmf