136
S:\HP892XX\USRGUIDE\manual\callscrn.fb
Chapter 6, Call Processing Subsystem
The CALL CONTROL Screen
SAT:
SAT: is divided into two fields:
he left-hand field displays the SAT frequency assigned to the voice channel being used by
the Test Set and the mobile station. A numeric value would only be displayed when the
Test Set’s Connected annunciator is lit (connected state). A “-” is displayed if a mobile
station is not actively connected on a voice channel.
The right-hand field (highlighted field) is used to set the SAT Color Code (SCC) to be
used on the designated voice channel (Chan: field description, on page 125 for more
information about the voice channel).
SCM:
This field displays the decoded station class mark information received from the
mobile station on the reverse control channel in response to a forward control
channel message. The
SCM: field is displayed only when the Display field is set
to
Data and a reverse control channel message has been decoded.
SID
This field is used to set the system identification number (SID) of the Test Set.
The
SID field is an immediate action field. If the field is selected and changed, the
signaling message(s) being sent on the forward control channel are immediately
changed. No change occurs to the current state (that is, active, register, page,
access, connect) of the Call Processing Subsystem.
System Type
This field is used to select the type of cellular system (AMPS, NAMPS, TACS,
JTACS) which will be simulated.
The
System Type field is an immediate action field. That is, whenever the
System Type field is changed, the change is reflected immediately in the
physical configuration of the Test Set. The control channel is immediately de-
activated, reconfigured, and then re-activated to reflect the change. This change
causes the Test Set to enter the active state).
If the Test Set is in the connected state (Connect annunciator is lit) and a change is made
to the System Type field, the connected state will be lost.
To Next Page
Loading...
