HP 8920A - GOTO L; RCHAN C; TCHAN C

332
S:\HP892XX\USRGUIDE\manual\decoscrn.fb
Chapter 8, Signaling Decoder Screen
Creating NMT Tests
GOTO l
Unconditionally jump to the label reference l.
Valid entries for the parameter l are integers from 0 to 255. The label reference
must exist within the program or an error will occur after the END statement is
entered.
All NMT test programs must contain an EXIT n, EXITX n, or GOTO l statement
immediately before the END statement.
RCHAN c
Set the RF Analyzer to the correct frequency for NMT channel
c.
Valid entries for the parameter
c are as follows: CC, TC1, TCM, TC2, TCA and AC. TC1
and TCM are synonyms as are TC2 and TCA.
The frequency setting is determined by the channel number in the appropriate encoder
field, the selected DUT, and the selected standard.
The parameter CC refers to the calling channel; TC1 and TCM refer to the main traffic
channel; TC2 and TCA refer to the alternate traffic channel; AC refers to the access
channel.
TCHAN c
Set the RF Generator to the correct frequency for NMT channel
c.
Valid entries for the parameter
c are as follows: CC, TC1, TCM, TC2, TCA and AC. TC1
and TCM are synonyms as are TC2 and TCA.
The frequency setting is determined by the channel number in the appropriate encoder
field, the selected DUT, and the selected standard.
The parameter CC refers to the calling channel; TC1 and TCM refer to the main traffic
channel; TC2 and TCA refer to the alternate traffic channel; AC refers to the access
channel.